Ball and Keg Logo Ball and Keg

Our Products

Buy the Ball and Keg - Keg Level Indicator from Ball and Keg

Keg Level Indicator

Buy the Dual Purpose Siphon from Ball and Keg

Ball's Up Floating Dip Tube

Buy the Temperature Control Loop from Ball and Keg

Temperature Control Coil

Buy the Dual Purpose Siphon from Ball and Keg

Dual Purpose Siphon

Ball's Up Floating Dip Tube

Ball's Up Floating Dip Tube
Ball's Up Floating Dip Tube - $16.50
24 inch long silicone tube
1/4 inch I.D. silicone tubing fits snugly over liquid diptube
2 inch Diameter Polypropylene Float
Trim silicone tubing to desired length and install over your keg's shortened liquid dip tube (we recommend you cut your diptube to 3" in length)
Overview
How It Works
How To Use

Draw clear beer from the upper layer of the liquid in your keg. Allows for quicker, clearer pours.

The float holds the silicone dip tube near the surface of the liquid in the keg.

Remove the existing liquid withdrawal dip tube. Trim it off to approximately 3” in length. Reinstall the 3” liquid dip tube, reach inside the keg and slide the silicone tube onto the 3” dip tube. The float end of the dip tube should rest on the bottom of the keg. The silicone tubing can be trimmed off as needed to make the tubing rest neatly on the center of the bottom of the keg.

Notes: A spare gas inlet dip tube can be used, but they are typically 1.5” in length and they are harder to reach inside the keg. A little water can be used to wet the silicone tubing to make it easier to slide on to the short dip tube.

Ball Ball Ball
Ball
Ball
Ball
Ball